Monday, April 11, 2011

Rear wheel becomes the front part 3

I have a spare set of forks, so I can mock it up on the bench rather than on the bike, which is outside and in the dark not long after I get home in the evenings.

Finished machining the rear hub to suit the front forks. You can see where I have taken the material off the cush drive side, removed material and re-sunk the bearing further into the hub and taken some material off the brake plate. I just need to make or get spacers to allow the 12mm axle to go thru the 17mm bearings.

No comments:

Post a Comment