Power output via DC to DC converter is 10 volts....Lower photo shows 4.7k potentiometer connected which is supposed to increase the output voltage.Then I got this email from the makers of the DC to DC converter:
Dear Mr,The M029 makes an input voltage nearly twice as high as the output voltage, the output voltage depends on the load connected (see diagram in the description).
The potentiometer can not increase the voltage, the potentiometer is used to lower the output voltage. The potentiometer must remain connected permanently.
Apparently this is not the case! The below text is from the instructions:
The potentiometer of 4,7 k linear should only be connected, if the output voltage may not pass over a determined rating. In that case, you should connect a voltmeter at the output of the module and regulate the potentiometer till the desired output voltage is indicated.
Any ideas anyone?
No comments:
Post a Comment